Developing Flexible Quinacridone-Derivatives-Based Photothermal Evaporaters for Solar Steam and Thermoelectric Power Generation

Solar-driven interfacial vaporization by localizing solar-thermal energy conversion to the air−water interface has attracted tremendous attention. In the process of converting solar energy into heat energy, photothermal materials play an essential role. Herein, a flexible solar-thermal material di-cyan substituted 5,12-dibutylquinacridone (DCN−4CQA)@Paper was developed by coating photothermal quinacridone derivatives on the cellulose paper. The DCN−4CQA@Paper combines desired chemical and physical properties, broadband light-absorbing, and shape-conforming abilities that render efficient photothermic vaporization. Notably, synergetic coupling of solar-steam and solar-electricity technologies by integrating DCN−4CQA@Paper and the thermoelectric devices is realized without trade-offs, highlighting the practical consideration toward more impactful solar heat exploitation. Such solar distillation and low-grade heat-to-electricity generation functions can provide potential opportunities for fresh water and electricity supply in off-grid or remote areas.     

基元阀在汽轮机进汽阀研究中的应用

阀碟型线对汽轮机进汽阀的性能影响很大，本文设计了三种形式的基元阀，通过数值模拟手段研究了阀碟型线对流场的影响；得出了不同阀碟形式的性能．     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

蒸汽活化对钙基脱硫剂孔结构及固硫能力影响的实验研究

本文用实验方法研究了在电站锅炉排烟温度条件下，水蒸汽对钙基脱硫剂的活化作用．实验结果表明，蒸汽活化使得脱硫剂孔结构发生了显著变化并明显改善了脱硫剂的固硫能力．这为进一步了解活化机理及开发省水，经济的排烟脱硫技术提供了依据．     

中高温工质在蒸发器中的换热模拟分析

本文采用分布参数的方法,建立了水源热泵中普遍采用的壳管式蒸发器稳态数学模型.通过中高温水源热泵试验台的实验数据同模拟计算结果的对比,验证了数学模型的准确性。应用此数学模型对中高温工质HTR01、HTR02及R134a在蒸发器典型制热运行工况,进行了模拟计算。得出了三种工质制冷剂侧换热系数沿管长的变化关系并对三种工质的换热性能进行了对比分析,为采用中高温工质的水源热泵换热器设计提供了参考依据.     

稀土添加剂对烃类水蒸汽重整镍催化剂性能的影响——水蒸汽吸附的TPD研究

用程序升温脱附技术,研究了添加稀土的烃类水蒸汽重整催化剂(Ni/α-Al_2O_3)对水蒸汽的吸附性能,同未加稀土的镍催化剂作了对比。结果表明,加有稀土的镍催化剂对水蒸汽的吸附能力主要是稀土的贡献。还原态催化剂对水蒸汽的吸附量比相应的氧化态多1.4倍。发现催化剂对水蒸汽的吸附能力不仅取决于浸渍方式,而且同稀土含量有关。当稀土含量较多时,催化剂表面上呈现出三个能量不同的吸附位。稀土含量少于1.3%时。对提高催化剂吸附水蒸汽的能力已作用不大。含稀土的镍催化剂吸附水蒸汽的能力大,正是其抗结炭性能耐硫性能好的原因。     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

Effect of the composition of nickel-containing composites based on stabilised zirconia on catalytic activity in methane steam conversion

A study was carried out on the composition and nature of the stabilizing additive on the activity of nickel-containing composites based on zirconia in the methane steam conversion. The methane conversions were 91–99% on Ni/ZrO₂(Y, Sc, Ce) at 700–800 °C.     

Properties and Characterization of Modified HZSM—5 Zeolites

Physicochemical and catalytic properties of phosphorus and boron modified HZSM-5 zeolites treated with 100% steam at 673K were investigated.The acidity and distribution of acidic sites were studied by infrared spectroscopy using pyridine as probe molecule and temperature programmed desortion (TPD) of ammonia.The structure of the samples was characterized by XRD,and the textural properties of the catalysts were determined by nitrogen isothermal adsorption-desorption measurements and scanning electron microscopy(SEM).The XRD results show that the modified samples have no novel crystalline phase,indicating a high dispersion of phosphorus and boron species.After treatment,the microporous volume and surface area of the samples markedly decrease,implying the bolockage of the channel.The nitrogen adsorption-desorption measurements suggest that the isothermal type of all samples is a combination of isothermal type Ⅰ and Ⅳ，and all hysteresis loops resemble the H4-type in the IUPAC classification.The total acidity of the modified samples,determined by pyrldine adsorption IR and TPD of ammonia,decreases in contrast to that of the parent HZSM-5.The conversion of n-heptane over P and B steammodified HZSM-5 is higher than that of P and B-modified HZSM-5 zeolites but lower than that of the parent HZSM-5.